KA565F/00/a2/05.02
5200 9853
release: 2
1
2
3
4
5
6
7
8
8
• Philips screw driver size 1
• flat screwdriver for M3 / M4
• unplug tool for antenna plug (order No. 5200 7646)
• Allen wrench AF 2.5 / AF 4 / AF 5
• eventually tweezers
HA
USER
HA
USER
HA
USER
MICR
OPILO
T FMR
HA
USER
MICR
OPILO
T FMR
IP 65
Order Code:
Ser
.-No
.:
Order Code:
Ser
.-No
.:
Messbereich
Measur
ing r
ange
Messbereich
Measur
ing r
ange
U 16...36
V DC
4...20 mA
U 16...36
V DC
4...20 mA
max.
20 m
max.
20 m
Made in Ger
man
y Maulb
u
rg
Made in Ger
man
y Maulb
urg
T
>70°C :
A
t >
85°C
T
>70°C :
A
t >85°C
stop
screw
set
screw
cover
front panel
process
connection
bore for
seal wire
locked
open
electronic
module
antenna cable
Hauser Maulburg
The following tools are required for the exchange:
9
unplug
tool
groove
Exchange of the parabolic antenna / flange for Micropilot S, FMR 533
In case of an antenna exchange, the replacement antenna must be identical with the original type. It is technically not allowed to install another antenna type.
Only identical, original E+H spare parts may be used.
The instrument may only be maintained and repaired by qualified personnel. The device documentation, applicable standards and legal
requirements as well as any certificates have to be observed!
0
1
2
0
1
2
Ex i-devices: The repair has to be performed such that the voltage isolation of the Ex ia circuits against ground is maintained..
If required, a test can be performed with 500 Veff over a time of 60 s.
The custody locking switch can be sealed for custody transfer applications. Access to the electronics can be revented by means of a custody locking switch
that locks the device settings. In this case, after any breaking of the seal (required for exchange of parts), the Micropilot must again be tested and sealed
by an official at commissioning!
Before disassembly, ensure that the operating voltage for the instrument has been switched off.
Preparation for antenna exchange:
The components are now disassembled, the housing
can be lifted off the process connection.
(description on next page)
Assembly is done in reverse order.
Special attention has to be payed to the connection of
the antenna cable (9).
Unscrew lid from electronic compartment (4 turns)
If applicable, push up hook and remove display from holder
Loosen screw at cover and remove cover
Open locking at front panel and eventually remove seal
Slightly push in both hooks at the module housing and ...
... pull off front panel
Unplug supply voltage, signal cable and display
Loosen 2 mounting screws at electronic module and pull
module out of the housing
Unplug antenna cable with unplug tool
1
2
3
4
5
6
7
8
9
parabolic antenna
