21
E-flite Super Cub 25e ARF Assembly Manual
4. Apply 2–3 drops of thin CA in each of the holes
to harden the surrounding wood. This will harden
the threads so the screws do not easily strip the
surrounding wood.
5. Install the control horn using two 2mm x 8mm
self-tapping screws and a #1 Phillips screwdriver.
6. Place a T-pin in the center of each of the three
hinges. This will center the hinges equally in the
elevator and stabilizer when they are installed.
7. Insert the hinges in the elevator. The T-pin will rest
on the edge of the elevator bevel.
8. Slide the elevator into position, guiding the hinges
into the slots in the stabilizer. Make sure the elevator
is installed so the control horn is facing down.
9. Remove the t-pins from the hinges and slide the
elevator tightly against the stabilizer. Check that the
elevator can move without rubbing the stabilizer at
the counter balance.