Step 10.
The micro-switch is used to turn the motor on and off
in flight. Use double-sided servo tape to attach the micro-switch
to the side of the servo as shown below.
Step 11.
A servo is used to activate the micro-switch through
the use of the servo arm. If you have not done so, trim three of
the four arms off of the servo arm, leaving the one that faces up
as you look down at the servo. You only need one of the arms to
activate the switch. Use double-sided tape to mount the servo to
the bottom of the provided plywood tray in such a position as to
allow the servo arm to depress (turns motor on) the switch when
the servo moves in one direction and release (turns the motor
off) the switch when the arm is moved in the opposite direction.
The motor should come on only when the micro switch is
depressed. The servo can be connected to the throttle servo so
that the micro-switch is activated when the throttle is full on.
Step 12.
Attach the servo to the plywood servo mount plate
using double-sided servo tape. Apply another section of double-
sided servo tape to the bottom of the mount plate to attach it into
the fuselage.
Step 13.
Place the plywood plate with the micro switch/servo
into the area of the fuselage aft of the motor near the arming
switch position and attach with double-sided servo tape.
12
