14
15
14
15
Additional Smartbind
™
Information
Prior to each flight, you should power on your transmitter and wait about five
seconds before you plug in the flight battery into the receiver. Doing this allows
time for the transmitter to scan and secure two open frequencies. If the flight
battery is plugged in too quickly and the link is missed, it may cause the receiver to
inadvertently enter bind mode. If this occurs simply leave the transmitter on and then
disconnect and reconnect the flight battery. Once the flight battery is plugged in, put
the helicopter on a horizontal surface as soon as you can (within two seconds) for
gyro calibration. Do not move/sway the helicopter during the calibration process.
Failure to do this will cause unstable flight performance.
Transmitter Control Identification
Note:
Before each flight you should ALWAYS turn the transmitter on before
connecting the flight battery to the 5-in-1 unit. After each flight, be sure to
always disconnect the flight battery from the 5-in-1 unit before powering
the transmitter off.
Mode 2
Throttle Trim Buttons
Aileron Trim Buttons
Elevator Trim Buttons
Rudder Trim Buttons
Mode 1
Elevator Trim Buttons
Aileron Trim Buttons
Throttle Trim Buttons
Rudder Trim Buttons
Rudder/Throttle
Functions
Rudder/Elevator
Functions
Aileron/Elevator
Functions
Aileron/Throttle
Functions
Summary of Contents for Blade MCX Tandem Rescue
Page 22: ...42 43 42 43 ...