20
E-flite Alpha Sport 450 ARF Assembly Manual
B. Use six 3-inch (76mm) pieces of low-tack
tape, three on the top of the wing and three on
the bottom of the wing, to hold the wing panels
together until the epoxy fully cures.
C. Use a paper towel and rubbing alcohol to
remove any excess epoxy from the wing before it
has a chance to cure. You may need to use two or
three clean paper towels to remove all the epoxy
residue from the wing.
4. Plug the leads from the aileron servos into the
Y-harness from the receiver that is plugged into the
AIL port of the receiver.
5. To fit the wing to the fuselage, rest it on the
fuselage as shown. The dowels at the front of the
wing will fit into the holes in the fuselage. Slide the
wing forward until the leading edge of the wing is
against the fuselage as shown in the bottom photo.
6. Position the wing bolt plate as shown in the
photo. The rounded end will face to the front of the
airframe. The holes in the plate will align with the
holes in the wing.