5
Fig. 1
Fig. 2
NEVER
dispose of batteries in
fire.
Failure to observe this precaution
may result in an
explosion
.
Dispose of batteries at your local hazardous material processing center.
ALWAYS
replace the battery in the remote control with the
same type of battery
.
Failure to do so may result in
personal injury
or
property damage
.
ALWAYS unplug
this fireplace heater
before assembly
or
cleaning, or before
relocating.
Failure to do so could result in
electric shock
,
fire
, or
personal injury
.
OPERATION
Read and understand
this entire owner’s manual, including
all safety information
,
before
plugging in
or
using
this product. Failure to do so could result in
electric shock,
fire, serious injury, or death.
Power
Make sure the ON/OFF switch, located on the control panel, is in the OFF position. Plug the power cord
into a 120V AC, 15 Amp grounded outlet (see
IMPORTANT SAFETY INFORMATION
on
Pages 2 and
3
). Make sure the outlet is in good condition and that the plug is not loose.
NEVER
exceed the maximum
amperage for the circuit.
DO NOT
plug other appliances into the same circuit.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature (239
°
F / 115
°
C), the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2. Turn the ON/OFF switch on the CONTROL PANEL to OFF.
Wait 15 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
If it switches off again,
UNPLUG THE HEATER RIGHT AWAY!
Have the outlets, wiring, and
breaker box inspected by a professional. Make necessary repairs before using the heater.
CR2032