E.F. Johnson Company 5100 ES, Service Manual

Page: 31 / 180

January 2007 5100 ES Series Portable Radio Service Manual 2-3
Battery, Accessory and Disassembly Information
unsquelched mode, and 90% in the receive squelched mode. The operating time may be
less if more time is spent in the transmit or unsquelched modes, or if the battery is not fully
charged or its capacity has deteriorated. Be sure to dispose of the nickel metal-hydride
(NiMH) battery pack in accordance with local waste regulations.
Figure 2.2
Belt Clip Installation
2.2 Belt Clip Installation
Remove the battery and slide the belt clip into the slot on the battery as shown in Figure
2.2. To remove the clip, simply slide it out. It is held in place by the chassis when the
battery is installed on the radio.
2.3 Accessory Installation
To connect an accessory such as a speaker-microphone to the transceiver, refer to Figure
2.3 and proceed as follows:
1
Remove the dust cover over the accessory jack on the side of the transceiver.
2
Insert the hook of the accessory connector into the slot on the side of the transceiver.
3
Hold the latch open, press the connector against the transceiver, and then release the
latch to lock the connector in place.
4
Install the included locking screw in the latch tab in the location shown.