User Manual EE360
Moisture in Oil Sensor | 22
5.4.1. Available TCP and UDP Ports
Modbus TCP (Port 502)
See “Modbus TCP/IP implementation guide” available at
www.modbus.org/docs/Modbus_Messaging_Implementation_Guide_V1_0b.pdf.
The unit identifier of the MBAP header is not used and can be any value from 0 to 255.
HTTP-Webserver (Port 80)
For a quick communication check enter the desired IP in a web browser and connect with the EE360 Ethernet
Module’s Webserver.
Fig. 16 Image from the E+E net web interface
Alternatively send an ICMP echo request (“ping”) to check correct communication settings.
UDP (Port 5234)
Backwards compatible communication protocol with EE36. Communication via Ethernet takes place by means of
UDP packets, which transport a command or a command response in EE36 protocol format as payload data. See
“Ethernet - communication protocol” available at
www.epluse.com/en/service-support/download-center
.
5.4.2. IPv4 Settings
Factory setting
IP Address
192.168.0.64
Subnet Mask
255.255.255.0
Gateway
192.168.0.1
DNS
192.168.0.1
Tab. 6
IPv4 settings
DHCP options can be set with jumper on the PCB.
Factory setting: DHCP disabled (static IP). Please refer to Fig. 24 below.
