Document:
Date
Created By:
ECO#
LPN00684X0001A0_A
3-9-2020
TMT
011592
INSTALLATION INSTRUCTIONS
E-WPS Series
www.e-conolight.com | 888.243.9445 | FAX: 262.504.5409
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before
installation.
DANGER
– Risque de choc – Couper l’alimentation
avant l’installation.
2. This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre
code électrique local. Si vous n’êtes pas familier avec ces
codes et ces exigences, veuillez contacter un électricien
qualifié.
3. Suitable for Wet Locations.
Adspte pour les Endroits Mouiles.
4. SUITABLE FOR MOUNTING WITHIN 1.2m (4ft) OF THE
GROUND
PEUT ETRE INSTALLE A MOINS DE 1,2 m (4 pi) DU
SOL.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
NOTE:
Knockouts in mounting base allow for mounting over a
31/2" or 4" octagonal junction box, a 4" square junction box, a
masonry box, a 4" round box, or a single gang box. Junction
boxes must be at least 1/2" deep for proper installation of fixture.
1.
Remove the mounting base from the fixture by loosening (do NOT
fully remove) the one or two (depending on fixture size) mounting
base screws on the bottom of the fixture and lifting the fixture off
the base. See
Figure 1.
2. Refer to
Figure 2 on next page
to determine the correct holes to
knock out for mounting over the junction box being used.
3. Route the supply leads from the junction box through the hole
locations in the center plug in the mounting base. Push one wire
through each opening in the plug.
4. Align the holes in the mounting base will the screw boss locations
on the junction box. Make sure rib on outer edge of mounting base
is facing upwards. Attach the mounting base to the junction box
using screws provided by others. See
Figure 3 on next page.
NOTE:
The bubble level inside the mounting base should be used
to ensure a level install of the fixture.
5.
For hands free wiring, position the fixture housing on top of the
mounting base by inserting the rib on the mounting base into the
slot on the top of the fixture. See
Figure 3 on next page.
6. Make wiring connections per
Fixture Wiring
section.
7.
Lift fixture housing off mounting base and rotate housing so that
slot in fixture housing is facing upward.
8. Insert rib on upper edge of mounting base into slot on top of
fixture.
9.
Push lower edge of fixture against mounting base and tighten
one or two (depending on fixture size) mounting base screws on
the bottom of the fixture to retain the fixture against the mounting
base.
10. A high grade caulking material, such as silicone rubber, should
be used where the mounting base meets the mounting surface to
ensure a watertight seal. Make sure that caulk is applied around
the entire perimeter of the mounting base. See
Figure 4 on next
page.
JUNCTION BOX MOUNTING
NOTES:
1. Fixture is only intended to be mounted with the light facing
downward. Do NOT mount as an uplight.
FIGURE 1
Fixture
Base
WPS01 & WPS03
One Screw
WPS05 & WPS08
Fixture
Base
Two Screws
