© Copyright e-con Systems. 2020. All rights reserved.
Streaming of e
-
CAM50_CU96 Board
This section describes the steps to stream e-CAM50_CU96 board.
The steps to stream e-CAM50_CU96 board are as follows:
1.
Unplug ROCK960 board from power.
2.
Connect the ROCK960 board HDMI interface with HDMI cable.
3.
Connect the USB keyboard and mouse using USB hub present in the ROCK960
board.
4.
Insert the prepared microSD card into the SD slot.
5.
Power ON the supply and wait for board to boot up.
After booting, the LEDs will start blinking and Debian desktop will open in the
monitor. You are now booting your newly installed operating system running on
SD card on the ROCK960 board as shown below.
Figure 18: HDMI, Keyboard or Mouse connected to ROCK960 Board
6.
Run the following command to check whether the e-cam50 kernel module
named ar0521_mcu is loaded.
$ lsmod
7.
Run the following command to load the module if the module is not loaded.
$ sudo modprobe ar0521_mcu
8.
Run the following commands to install media-ctl and V4L2 application.
$ sudo apt-get update
$ sudo apt-get install v4l-utils
9.
Run the following command to check the media control entities.