-1-
WARNING:
SHOCK HAZARD
Never connect E-Blox
®
Circuit
Builder to the electrical outlets in
your home in any way!
WARNING:
CHOKING HAZARD
Small parts. Not for children
under 3 years.
!
WARNING:
MOVING PARTS
Do not touch the fan while it is
spinning.
WARNING:
Only use the battery holder with
the cover securely in place.
!
!
WARNING:
Always check your wiring before turning on a circuit. Never leave a circuit
unattended while the batteries are installed. Never connect additional batteries or any
other power sources to your circuits. Discard any cracked or broken parts.
Adult Supervision:
Because children’s abilities vary so much, even with age groups, adults should exercise discretion
as to which experiments are suitable and safe (the instructions should enable supervising adults
to establish the experiment’s suitability for the child). Make sure your child reads and follows
all of the relevant instructions and safety procedures, and keeps them at hand for reference.
This product is intended for use by adults and children who have attained sufficient
maturity to read and follow directions and warnings.
Never modify your parts, as doing so may disable important safety features in them,
and could put your child at risk of injury.
FCC Notice:
Please note that changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no gaurantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment
and receiver. • Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
EBX59_Manual_051717_Layout 2 5/17/2017 11:09 AM Page 2
