6
BEEP/LED CODES
The three state-of-charge LEDs on the throttle controller
indicate battery state of charge. The E-Bike™ uses these
LEDs and three distinct beeps to alert you to particular
conditions. The following chart describes these signals and
their various meanings.
CODE
MEANING
BEEP
LEDs
Good Beep
The system has been
1 continous
checked and is
beep sounds
operational.
for 1 second.
Bad Beep
A problem exists in a
4 sets of 4 short
system or component
beeps
Pedal Assist
The system requests
3 short beeps
pedal assist. Sounds
every 16
when on a steep hill
seconds
or when the motor or
controller approaches
an overheat condition.
System ON
Whenever the power
Good Beep
The state-of-
knob is turned ON, the
charge LEDs
system performs a
flash together
series of checks. This
3 times.
signal indicates that
the E-Bike™ is ON
and ready for
operation.
CODE
MEANING
BEEP
LEDs
Throttle Fault This code occurs
Bad Beep
All 3 state-of-
whenever you turn the
charge LEDs
power knob ON while
flash continous-
pressing the throttle or
ly until the fault
if the throttle is faulty.
is cleared and
Turn the power OFF,
until the power
release the throttle,
knob is turned
and turn the power
OFF then ON
knob to ON. If the
again.
code persists, have
the throttle checked
by an authorized
E-Bike™ dealer.
Battery
The battery has
None
Green LED on.
state-of-
100% to 80% of
charge
run time remaining.
80% to 60% of
None
Green and
run time remaining.
yellow LEDs on.
60% to 40% of
None
Yellow LED on.
run time remaining.
40% to 15% of
None
Yellow and red
run time remaining.
LEDs on.
Low Battery
15% to 5% of run
None
Red LED on.
time remaining.
Very low
Less than 5% of run
Bad Beep
Red LED
battery
time or 1 minute of
flashes.
operation remaining.
Motor shut
The power to the
Bad beep
Red LED
off
motor has been shut
flashes.
off. You must pedal.
