Manual for Power Pack compatible for Yamaha* PW Series drive system
* Yamaha is a trademark of the YAMAHA CORPORATION
Page
5
of
12
Safety notes for charging
Please pay particular attention to the following points when charging:
- Connect the charger only to a suitable mains supply.
- Do not charge NiCd, NiMh or primary cells!
- Use the charger only with the appropriate Power Packs of E-Bike Vision!
- When not using for a longer period, disconnect the mains supply and also connected
batteries.
- The charging time varies depending on the battery’s capacity and charger type.
- Do not charge the battery below 0° and not above 45° C. The battery management system
will not allow to start the charging process.
- Please charge your Power Packs only under supervision and on a non-combustible surface
(both battery and charger).
- The charger is designed for operation in ventilated, dry and dust-free environment. Never
expose to rain or extreme heat. Allow adequate air circulation.
- Do not cover the charger, nor the battery.
- Ensure that that the plugs and sockets of the charger are not damp or contaminated.
- Do not touch plugs and sockets of the charger with wet hands.
- Do not try to convert or disassemble the charger.
- Before the charger is connected to the mains, please ensure that line voltage matches to
the supply voltage of the charger. The charger’s needed voltage is indicated on it‘s
nameplate on the backside.
- A charger with a damaged power supply cord or plug must not be connected to the
electrical grid and must promptly replaced or repaired by the E-Bike service center.
- Penetration of water and moisture into the charger must be avoided in any case. Should
this have happened, power off the charger (by turning off the fuse) immediately. Disconnect
the charger from the mains and let it be checked by the E-Bike Vision service center.
- A sudden temperature change from cold to hot, there could be condensation water on and
in the charger. In this case, wait for connecting to the mains until the charger is as warm as
the room. Try to avoid this case by storing the charger where you use it.
For maximum life of your battery, charge it only within 10° and 30° C temperature range.
