18
Troubleshooting
The platter doesn’t turn although the unit is switched on:
•
The unit is not connected to the mains power supply (the building’s electrical system).
•
No mains power is being delivered at the socket.
•
The drive belt is not fitted properly or has slipped off.
No signal through one or both channels:
•
No signal contact from the cartridge to the internal tonearm wiring; or from that to the arm
lead; or from that to the phono box; or between that and the amplifier. This could be due to a
faulty plug, broken wire or loose solder joint in the plug/socket connection.
•
Phono input not selected at amplifier.
•
Amplifier not switched on.
•
Amplifier or speakers are defective or muted.
•
No connection to the loudspeakers.
Strong hum on phono input:
•
No ground connection from cartridge or arm or arm cable to amplifier, or ground loop.
Distorted or inconsistent sound from one or both channels:
•
Possible Causes: Turntable is connected to wrong input of amplifier, MM/MC switch is
incorrectly set, needle or cantilever damaged, Wrong RPM, drive belt overstretched or
dirty; platter bearing needs lubrication or is dirty or damaged.
Service:
Should you encounter a problem that you are not able to identify or alleviate despite
the above information, please contact your dealer for further advice. Only when the problem
cannot be resolved should the unit be sent to the responsible distributor in your country. Please
keep the original packaging, as repairs will only be performed if the unit is returned in its appropriate
packaging.
Never return a turntable without making sure that is it properly disassembled and correctly packaged
in the original packaging according to the supplied diagram. Please remove the feet, counterweight,
platter, cartridge and belt and pack them separately. Fit the cartridge protection cap. Insert the
transport lock for the tonearm prior to carefully packaging the turntable.
Warranty: See enclosed warranty from your local distributor
. The manufacturer accepts no
responsibility for damage caused by failing to adhere to these instructions for use and/or by
transportation without the original packaging. Modification or change to any part of the product by
unauthorized persons releases the manufacturer from any liability over and above the lawful rights
of the customer.
The information above was correct at the time of going to press. The manufacturer reserves the
right to make changes to the technical specifications without prior notice or obligation to modify
existing units, as deemed necessary to uphold the ongoing process of technical development.
E.A.T. European Audio Team is a Registered Trademark of Jozefina Lichtenegger. The contents
of the USA version of this manual are Copyright © 2017. VANA. Ltd based on original
copyright material from EAT 2017.
Summary of Contents for B-Sharp
Page 1: ...B Sharp Turntable USA Version 4 0...
Page 6: ...6...
