MAIN COMPONENTS
1. Operating buttons (two speeds)
2. Handle
unit
3. Blending
attachment
4. Blending
blade
5. Power cord (not shown)
6. Wall mounting bracket (not shown)
POWER SUPPLY
The appliance must only be connected to mains electricity of 230V and 50Hz.
Always ensure the mains voltage where you’re using the appliance corresponds
to the value shown on the nameplate of the appliance.
USING THE APPLIANCE
Introduction, when to use the appliance
The appliance can be used to process soft foods, to blend liquids and mix shakes, sauces or baby food.
Before use
1. Unpack the appliance and remove all the packing materials.
2. Inspect the appliance and the accessories carefully to verify their soundness and undamaged condition. Only
perfectly sound and damage-free appliances may be connected to the electrical mains.
3. Before the first use clean the motor unit and the stainless steel attachment as described
the "Maintenance and cleaning" section.
4. If the blender is to be stored within its wall mounting bracket, ensure that this bracket is installed where the
mounted blender will not hamper kitchen work or be dislodged, while being adequately distant from hot
surfaces and objects. For example do not position the appliance above a stove, oven or hotplate. Also, do not
mount the bracket above a sink, from where the appliance or power cord could fall into the water.
Always unplug the appliance before storing it in its wall mounting bracket.
•
Never use the appliance with its power cable damaged, if operation is erratic or it is otherwise damaged. In
these cases take the appliance to a specialised service station for checking, repair or adjustment. Only skilled
experts in the service station are authorised to repair the appliance.
•
You must not disassemble the appliance, remove its cover or to try to repair it. Ignoring this advice could
cause a serious accident. There are no parts in the appliance that can be repaired at home or used for any
other purpose. Never operate the appliance with a damaged mains cable or connector. Do not use the
appliance if it fails to work normally or if it has been dropped or damaged. If the appliance becomes faulty for
any reason or if any moisture is allowed inside, take it to an authorised service engineer for checking and
repair. Only service engineers who have been trained and approved should repair the appliance. The
manufacturer cannot take any responsibility for unauthorised repairs or for any circumstances resulting from
not following the instructions.
• Special
instructions:
Attention!
The appliance was engineered wait for intermittent use. It is very important to wait for at least
10 minutes after a maximum 1 minute of operation. If the blended material is denser than
average or when chopping, reduce the time of use to even less then the 1 minute operation.
During pauses always unplug the appliance. Disregard for the instruction about pauses can result
in damage to the appliance and will be considered improper use.
The manufacturer will not be held liable for any failure of the appliance caused by or originating
from exceeding the time established for continuous operation or non compliance with the times
prescribed for waiting. The manufacturer will also not be liable for damage to the blending
blades and the drive of the blending blades caused by improper use (e.g. improper cleaning,
maintenance, dry running), or overload (e.g. damages caused by accidental or deliberate
processing of hard materials).
Please keep this instruction manual. If you give the appliance to anyone else,
you must give them this instruction manual, too!
9
HBL-180
EN
8
HBL-180
User'sManual for HBL-180:User's Manual for HBL-180 2011.01.20. 12:40 Page 8
