From lab to production,
providing a window into the process
-16-
www.dynisco.com
Rev: 1217
P/N: 974124
ECO: 27882
8. Maintenance
8.1 Maintenance
8.1 Maintenance
8.2 Repair/disposal
8.3 Warranty
Mounting and electrical connection of the PT must be done by specialists
with EMC training, following all applicable regulations, and in
pressureless, voltage-free
condition with the
machine switched off.
The machine must be secured against being switched back on!
Burn hazard!
The PT can be very hot when removed.
Wear protective gloves!
ESD sensitive component. Electrostatic discharge may damage the PT.
Take ESD precautions.
Always remove the PT before cleaning the machine with abrasives or steel
wire brushes or suchlike.
Removing the transmitter if the medium is in solidified condition can
damage the diaphragm of the PT.
Do not clean the screw-in section of the PT with hard objects. This will
damage the PT!
Always use a torque wrench applied to the designated hexagon collar
when screwing the PT in and out. Do not apply the tool to the housing or
housing/electrical connection!
16
17
17
