6
Installation instructions
DX-TVM113
STEP 2 -
Option 2: Installing on a solid concrete* or concrete block wall
CAUTION:
To prevent property damage or personal injury, never drill into mortar between blocks. Mount wall plate
directly onto the concrete surface.
1
Align the wall plate template (
R
) at the height you determined in the previous step, make sure that it is level,
then tape it into place. Use a pencil to mark the lag bolt hole locations (4). Remove the wall plate template.
2
Drill pilot holes to a depth of 2.5 in. (63.5 mm) using a 1/2 in. (13 mm) diameter masonry drill bit.
3
Insert the concrete wall anchors (
Q
) into the pilot holes and use a hammer to make sure the anchors are flush
with the concrete surface.
4
Align the wall plate (
A
) with the anchors, insert the lag bolts (
P
) through the lag bolt washers (
O
), then
through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall plate.
CAUTION:
• Avoid potential injuries or property damage!
• DO NOT over-tighten the lag bolts (
P
).
.
You’ll need
R
2.5 in.
(63.5 mm)
* Minimum solid concrete thickness: 8 in. (203mm)
* Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm).
* Minimum horizontal spacing between fasteners cannot be less
than 16” (406 mm).
P
(4)
Drill
1/2" masonry
drill bit
1/2" socket
wrench
Level
Q
(4)
Hammer
Wall plate (
A
)
Pencil
O
(4)
DX-TVM113
Wall Plate Template • Gabarit • Plantilla
Note
: For wood frame installations, use a stud finder to locate wood
studs first.
Remarque
: Pour une construction à ossature de bois, localiser
d'abord les montants en bois, à l'aide d'un détecteur de montants.
Nota
: para la instalación en construcciones de armazón de madera,
primero debe localizar las vigas de madera con un localizador de vigas.
http://san.us/286
Need more information about your mount? Scan this QR code or visit www.dynexproducts.com.
<FR>
Need more information about your mount? Scan this QR code or visit www.dynexproducts.com.
<SP>
Need more information about your mount? Scan this QR code or visit www.dynexproducts.com.
Tools Needed
Outils nécessaires
Herramientas requeridas
Top
Haut
Parte superior
Top
Haut
Parte superior
V1 13-0140
Wall plate template (
R
)
Tape
DX-TVM113_13-0614_MAN_V2_EN-A4.fm Page 6 Friday, June 7, 2013 7:38 AM
