Center
column
locking
screw
V1 ENGLISH 14-0372
Storing your tripod
1
Remove your camera.
2
Loosen the center column locking screw. Lower the column as
far as it will go, then tighten the locking screw.
3
Collapse the legs.
4
Press the leg release buttons and push the legs in.
5
Store the tripod in the carrying case.
Important safety instructions
• Make sure that all leg locks are correctly tightened and that the
legs are fully opened before use.
• Do not carry or transport your tripod with camera equipment
attached (for example, over your shoulder or cradled in your
arms).
• Do not expose your tripod to excessive heat or cold, or use near
any flame or fire.
• Do not oil or grease any part of the tripod.
• Do not use any solvents or thinners to clean your tripod. Use
only a mild detergent and wipe dry with a soft, lint-free cloth.
• Do not exceed the load limit of this tripod.
Specifications
• Maximum operating height : 66.5 in. (168.9 cm)
• Minimum operating height: 22.64 in. (57.5 cm)
• Folded height: 24.8 in. (63 cm)
• Net weight: 4.3 lbs (2 kg)
• Max operating load: 11 lbs (5 kg)
• Number of leg sections: 4
• Quick release thread: 1/4 in. (0.6 cm)
• Material: aluminum alloy
One-year limited warranty
Visit www.dynexproducts.com for details.
Contact Dynex:
For customer service, call 800-305-2204 (U.S. and Canada) or
01-800-926-3020 (Mexico)
www.dynexproducts.com
DYNEX is a registered trademark of BBY Solutions, Inc.
Registered in some countries.
Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richfield, MN 55423 U.S.A.
©2014 BBY Solutions, Inc. All Rights Reserved.
QUICK SETUP GUIDE
DX-TRPMN665
66.5" Tripod-Monopod
Combo
Before using your new product, please read
these instructions to prevent any damage.
Using your tripod
1
To adjust your camera to portrait position, loosen the vertical tilt
lock knob, rotate the plate up to 90°, then tighten the knob.
2
To adjust horizontal tilt, turn the pan locking knob
counter-
clockwise, tilt the tripod head as desired, then tighten the handle.
3
To pan, turn the pan locking knob counter-clockwise, pan the
tripod head, then tighten the knob to lock in place.
Note
: For maximum stability, always make sure that your camera lens is
over a leg.
4
To adjust the vertical tilt, loosen the vertical tilt handle, then use
the handle to adjust the vertical position. Tighten the vertical tilt
handle.
Converting to a monopod
1
Loosen the center column locking screw, and remove the center
column/monopod leg (with the pan head).
2
With one hand, grab all the twist screw leg locks on the
monopod leg and twist them counterclockwise to loosen them.
3
Extend the leg sections, starting with the thickest section, to the
height you want.
4
Twist each leg lock clockwise to tighten it.
Caution
: Incorrectly securing a leg lock can cause the monopod leg to
retract unexpectedly and could result in damage to the monopod or to
the attached camera or camcorder
Vertical tilt
lock knob
Rubber
foot
Twist
locking
screw
Monopod leg
