3
Installation Methods
METHOD 1: CONNECTION OF THE ADP-2 TO A NORMAL STEREO SYSTEM
CONSISTING OF A PAIR OF LOUDSPEAKERS IN FRONT AND AN INTEGRATED
PRE-MAIN AMPLIFIER
A small pair of extra speakers of good sensitivity and some speaker wire will be required.
Ensure that your amplifier is switched off and unplugged from the wall socket. Then:
1) Disconnect the speaker wires from the speaker output terminals of your existing amplifier.
2) Connect these wires to the terminals of the Adp 2 marked "TO FRONT SPEAKERS".
3) Using an additional pair of speakers wires of suitable length, connect one end to the Adp-2
terminals marked "FROM FRONT AMP" (FRONT AMP means your existing amplifier).
4) Connect the other end of the additional speaker wires to the speaker terminals of your existing
amplifier.
5) Using speaker wire, connect the speaker terminals of the additional pair of speakers to the
terminals of the Adp-2 marked "SUB SPEAKERS"
NB In making these connections, be sure to observe the correct polarities ie the speaker wire
connected to the + or red terminal of the amplifier goes to the + or red side of the Adp-2 and
speakers, and the - or negative side to the negative terminals.
Summary of Contents for DV-SS Adp-2
Page 2: ...2 ...
