Dynaudio Sub 6, User Manual, Page: 30 / 35

high-pass filter ensures that low frequency signals below 80Hz are not passed to satellite speakers connected to
the subwoofer outputs.
Trigger (5 - 12VDC = on)
Select to enable or disable trigger input switch on.
Left speaker distance
Select to specify the distance in centimetres of the left main speaker from the listening position.
Right speaker distance
Select to specify the distance in centimetres of the right main speaker from the listening position.
SUB distance
Select to specify the distance in centimetres of the subwoofer from the listening position.
Using Distance compensation
The default setting is 100 cm.
The distance compensation uses the difference between the set Left speaker distance , Right speaker distance &
SUB distance values to calculate the gain offset and delay required to correctly align your loudspeaker responses.
Due to boundary and room artefacts, this distance may not be the exact distance measured. Some trial for the
distance setting may be required.
Factory Reset
Select to return your Sub 6 to its default settings.
Software version
Displays the installed firmware version.
Sub 6 In Use
Once installed and configured, your Sub 6 should require little attention other than perhaps occasional volume
control adjustment to suit different types of programme material.
Grille Removal and replacement
The Sub 6 can be used with its grilles fitted or removed. To remove the grilles simply pull them carefully away from
the cabinet. To refit a grille align its pegs with the fittings on the face of the cabinet and gently push the grille home
to secure it in place. Always take care not to damage the moving parts of the drive units when removing or
replacing grilles.
Cleaning your subwoofer
Brush the grille surfaces with a soft brush and the cabinet surfaces with a clean lint-free cloth. Do not use a
vacuum cleaner. If you wish to use a cleaning agent, apply it to the cleaning cloth and not directly to the
subwoofer. Test a small area first, as some cleaning products may damage some of the surfaces.
Support
Should you require help or advice there are a variety of support options for Dynaudio products. These can be
found at dynaudio.com.
Note
Distances are specified in the Sub 6 configuration menus in order to equalise the signal arrival times from the
subwoofer and main speakers at the listening position. This ensures that the phase relationship between the
subwoofer and main speakers is correct and that they integrate optimally.
For a central listening position the Left and Right speaker distances should be equal.
If two subwoofers are used their distance to the listening position should be specified individually.
30 Sub 6 User manual