SD-BOX INSTRUCTION MANUAL, CODE: DYN 81.01.00
Date: 03/03/2020
Version 00
- 20 -
6. OPERATING REQUIREMENTS
6.1.
FIRST START UP
After the first start-up, the “RESET” button has to be pressed to restart the system.
The "RESET" button does not have to be pressed after a power cut.
6.2.
SETTING THE COIL DE-ENERGISATION WAIT TIME WITH THE CAR AT LEVEL
The SD-BOX coil de-energisation wait time can be modified when the car is at floor level without
moving it. The default value is 10 minutes but can be changed in the range from 1 second to 10
minutes.
6.3.
SETTING THE FAILURE OUTPUT RELAY
•
“1” – The FAILURE output will change status, the normally open (NO) contact will close
and the normally closed (NC) contact will open if any error is detected in the SD-BOX.
•
“0” – The output is set to show the status of the coil. At this value, the output will change
status: the normally open (NO) contact will close and the normally closed contact (NC)
will open, depending on the coil status, whether energised or at rest.
6.4.
AUTOCHECK TEST FUNCTION
This test the proper operation of the SD-BOX, such as the LEDs, relays and coil control.
6.5.
VERIFICATION TESTS
Before commissioning and also periodically, the following verification test procedure must be
performed:
Test 1
- Arrival at floor level and opening the doors:
•
Press the “RESET” button.
•
Make a call.
•
Wait for the car to reach its destination and for the doors to open.
•
Check the LEDs are in the status indicated in the following table:
LED
On
Off
POWER
X
STAND-BY
X
BATTERY CHARGING
X (if the battery is charging)
X (if the battery is charged)
BATTERY FAILURE
X (if the battery is discharged
or not connected)
X (if the battery is charged
and connected)
FAILURE CONFIGURATION
X (if configured to show
system fault at output)
X (if configured to show
coil status at output)
MANUAL RESCUE/BYPASS
X
Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer
area in Dynatech’s website in order to consult the full manual; http://customers.dynatech-elevation.com/
Summary of Contents for SD-BOX
Page 2: ......
