Dynasty Spas Spa & Hot Tub 2016, Operator'S Manual

Page: 32 / 76

Spa Operator’s Guide
Sec1:30
GENERAL PRE-OPERATION INSTRUCTIONS
Priming Pump For Electric Packs
The power pack system is located under the skirting. The equipment can be
serviced by simply removing the door. The door is located on the side of the
spa where three panels are located, usually on the side of the spa with the
lounger, or the side where the topside control panel is located.
It is important to make sure that all of the air is out of the pump(s) before
operating. To do this follow procedures below:
• Turn off power at the breaker
• Make sure the gate valves are open
• Fill the spa with water going thru the filter
• Turn the power on at the breaker
• Start the pump on low speed and water should start circulating within
one to two minutes. If water does not start circulating, turn pump from
low to high until water is flowing.
• If pump still does not prime, please see “Trouble Shooting Guide”
located in the back of this manual
Note: Equipment style and location will vary by model
Set thermostat, located on top side control panel, to desired temperature and continue
heating until desired temperature has been reached.
WARNING: Do not run spa with gate valves closed or run pump with
no water circulating in spa for long periods. This could damage the
spa equipment.
WARNING!
NOTE!
The SPA FROG In-line System is built right into the spa and
uses a mineral and bromine cartridges.
For easy top loading of
replacement cartridges, simply open the cap,
pull up the holder and snap them in.
Or call
1-800-222-0169 Toll Free
kingtechnology.com
to order your Spa Frog products
Terri - can ref from kingtechnology.com
L1
L2
N
G
4
3
5
6
7
8
1
1 Ozonator
2 LED Controller
3 2nd High Performance Pump
4 Power Supply
5 Gate Valve
6 Flow Thru Heater
7 Equipment Pack
8 Dual Speed High Performance Pump
9
2
Priming pump for electrical packs