background image

4

5

STEAM THE WEEDS AWAY

Triple Root Spike Technology

For weeds in the lawn, use the Triple Root Spike (TRS) 

(7). Position the TRS over the center of the weed and 

push it fully into the ground. Pull trigger and release 

steam for  approximately 5-10 seconds. The unique 

design (patent pending) kills the weed by directly 

attacking the root from 3 directions, at over 300°F. Move 

to next weed and repeat. The TRS nozzle will only effect 

the weed terminated and not the surrounding grass. 
The weeds will wilt, collapse, and die within 24-48 

hours. 

Do not pull or dig up weed; simply leave the weed in 

place to further decompose, completely.

Speed Weed Cone

For weeds and moss between paving stones, hardscape 

areas, and vegetable gardens, attach the Speed Weed 

Cone (8). Apply the cone over the weed. Apply the steam 

trigger (2) for 5-10 seconds, move to the next weed and 

repeat. 

Precision Power Jet Tip

For weeds or moss in tight places with limited access, 

attach the Precision Power Jet nozzle (9), point to the 

weed and apply the steam for 3-4 seconds, move to the 

next weed and repeat. 

Precision

Power Jet Tip

Triple Root Spike

Technology

Speed Weed

Cone

GETTING ACQUAINTED
1

Handle Operation.

Locate the Steam Release Trigger (2) and Trigger Lock 

(3) on the Steam Handle (1). The Lock has two positions, 

OFF/LOCK, and ON. Press the front of the Trigger Lock to 

lock (A), press the back of the Trigger Lock to unlock (B).

2

Releasing Steam.

When the Pressure Gauge (6) enters the red zone, your 

DynaSteam is ready to go (maximum pressure = 65 PSI). 

Press Green Trigger Lock (3) to the ON position (B) and 

pull the Steam Release Trigger (C) to release a burst of 

steam. Release trigger to stop steam.

3

Continuous Steam Operation.

To release steam for an extended period without holding 

the trigger, pull trigger (D), then press the green lock in 

the OFF/LOCK position (E). This will lock the valve open 

and release a continuous stream of steam until the ON 

button is pushed again  .
Continuous steam is only recommended to release 

excess steam before emptying contents.

4

After Using.

Lock trigger in OFF position to prevent accidental 

operation. With trigger in open position, depress Trigger 

Lock switch (3).

1)

 

Make sure DynaSteam is unplugged and the power is 

in the OFF position (14).

2) 

Unscrew Pressure Cap (5) by turning counter-clock-

wise.

3) 

Using the measuring cup (10) and funnel (11), fill the 

DynaSteam with up to 6 cups of water. (This will provide 

approximately 35 minutes of steam)

4) 

Replace the pressure cap by turning clockwise and 

fasten tightly.

5) 

Attach the accessory or tool you plan to use to the 

Steam Handle (1).

6) 

Plug the machine in and press power switch (14) to 

the ON position. Two lights will illuminate. The red switch 

light (14) is the power indicator. The orange heat light 

(15) indicates that the machine is building up steam 

pressure. When the machine is first turned on, this light 

will illuminate and can take up to 10 minutes to reach 

the correct pressure level depending on the amount of 

water in the tank. On the pressure gauge (6), the max 

pressure will be approximately 65 PSI.  
The orange heat light indicator will alternate on and off 

as the steam pressure is regulated. Releasing the steam 

trigger will allow the steam pressure to build up.

Steaming while the pressure gauge is in the red zone 

will produce good results. 

If pressure falls out of the 

red zone, pause steaming to regain the maximum 

pressure. The steam pressure should build up again in 

less than 40 seconds.
If the steam trigger is pressed under low pressure 

(yellow zone of gauge), only insufficient low temperature 

steam or hot water may come out.

USING DYNASTEAM FOR THE FIRST TIME

FOR BEST

RESULTS

Apply Steam For 

5-10 Seconds While

Weeds Are Actively

Growing In Sunny

Dry Conditions.

TRS - Triple Root Spike

Speed Weed Cone

3. WEEDS DIE IN

  24-48 HOURS

2. APPLY STEAM

Fully Trap Steam Over Weed

1. LOCATE WEED

Precision Power Jet

ENGLISH 

ON/OPERATING

POSITION

CONTINUOUS

“LOCKED ON” POSITION

“LOCKED OFF”

POSITION       

A

(2)

STEAM

TRIGGER

(1)

STEAM

HANDLE

(3)

TRIGGER

LOCK

(UN-LOCKED)

(3)

TRIGGER

LOCK

(LOCKED)

B

E

D

C

Summary of Contents for DS2000














Reviews: