40
Dynaset Oy | Menotie 3, FI-33470 Ylöjärvi, Finland | tel: +358 3 3488 200 | [email protected] | www.dynaset.com
HIGH PRESSURE WATER PUMPS
MAINTENANCE
6.2. HYDRAULIC FLUIDS
Wide range of standard hydraulic fluids can be used with DYNASET hydraulic
equipment. Depending on the operating temperature, following mineral hydrau-
lic oils are recommended:
Mineral hydraulic oil
Operation temperature up to
ISO VG 32S
60 °C
ISO VG 46S
70 °C
ISO VG 68S
80 °C
NOTE!
Recommended oil viscosity is between 10 to 35 cSt when operating at nor-
mal operating temperature.
Synthetic and bio-oils can also be used if their viscosity characteristics and lubri-
cating efficiency are similar to the mineral oils.
Automatic transmission fluids and even engine oils can be used, provided that
they are allowed to be used in hydraulic system of your base machine.
For the hydraulic fluid change interval follow the base machine’s maintenance
instructions.
To use special hydraulic fluids with DYNASET equipment, please contact the near-
est DYNASET representative for more information.
6.3. CLEANING THE HPW PUMP
ATTENTION!
Keep the HPW pump clean to enable its safe and longlife operation. Check
and clean your HPW pump after every work shift.
Summary of Contents for HPW 1000
Page 2: ......
Page 61: ...DYNASET OY all rights reserved...
