Dynapac DFP9, Operating Instructions Manual

Page: 83 / 112

4. Slightly loosen the fastening screws (2) on both sides.
5. Pull the engine carrier forward, remove and replace the V-
belt (1).
6. Install the new V-belt and pull the engine carrier back.
7. Tighten the fastening screws (1) on both sides.
8. Check tension of V-belt, tighten if necessary.
ð
Compression measurement: approx. 5 mm (0.2 in).
9. Assemble the V-belt guard (1) with fastening screws (2).
10. Check the V-belt tension again after 25 operating hours,
tighten if necessary.
8.8.3.1 Checking the frequency of the base plate
Keep feet and hands clear of the vibrating base plate.
2
B-834-0170
1
Fig. 71
1
B-834-0171
Fig. 72
Fig. 73
B-834-0144
1
2
Fig. 74
Maintenance – Annually
DFP9 83