Dynamix DW IAD - 162, User Manual

Page: 103 / 128

IAD Gateway User Manual
Parameter Usages:
-print: Print current sysconf settings.
-idtime: Set the duration (in second) of two pressed digits in dial mode
as timed out. If after the duration user hasn’t pressed next number, it
will dial out all number pressed (1-10 seconds).
-service: set SIP Phone to be normal mode or under hotline mode.
(sysconf –service 0/1, 0 for normal service, 1 for hotline service.)
-keypad: DTMF replay type. When value is “1”, IAD Gateway will
transfer DTMF signal via RTP payload as defined in RFC2833. When the
value is set to “0”, the DTMF type is set as In-band.
-faxtype: FAX Payload Type. range: 96~128 inter-used:100,102~105.
-2833type: RFC2833 Payload Type. Range: 96~128 inter-used: 100,
102~105.
-lcdrop: Disconnect Supervision (Loop Current Drop) (ON:1 / OFF:0).
-droptime: Period of Loop Current Drop (ms).
-eod: It will transfer the DTMF in [#] if users disable the end of dial
function. Users have to press the keypad in [#] if the end of dial
function is enable.
Note:
User can also define IP address here in P2P mode, once user press
“#”, Gateway will call out this IP address.
-callerid: Support Bell Core, DTMF caller ID and NTT caller ID function.
After the first ring at destination site, device will send line number as
caller ID to called site.
-dtmfstart: DTMF Caller ID Start Symbol.
-dtmfstart: DTMF Caller ID End Symbol.
For example:
- 97 -