12
D. Installing the REAR PANEL
1. Remove the protection paper from the buckles on the REAR WALL PANEL. Place the REAR
WALL PANEL up against the FLOOR PANEL with the ¼ round molding resting on the FLOOR
PANEL. Next, attach the REAR WALL PANEL to the RIGHT SIDE WALL PANEL and use the
buckles to latch together. Do the same for the LEFT SIDE WALL PANEL. (see Figure 10)
Figure 10
E.
Installing the BENCH HEAT EMITTER PANEL and BENCH
1. Installing the BENCH HEAT EMITTER PANEL can be a little tricky. You will need to slide the
BENCH HEAT EMITTER PANEL into place at an angle as indicated in the pictures below.
(see Figure 11)
2. Plug in the BENCH HEAT EMITTER connector to the corresponding inlet located on the right
side of the REAR WALL PANEL. Also plug in the FLOOR HEAT EMITTER PANEL connector
to the corresponding inlet on the left side of the REAR WALL PANEL.
3. Install the BENCH at an angle as also seen in Figure 11. Connect the connection for the
Accent LED lighting on the underside of the bench. Please note that one end of the LED
lighting wire will have an open connection. Then slide it over the horizontal bench guides on
the side panels. Slide the BENCH all the way in and against the REAR WALL PANEL. Make
sure to install the BENCH with the smooth and finished side facing upward. If screws were
provided, use them to screw down the bench.
