Dynalink RTA100+, User Manual

Page: 19 / 88

13
4
Local PC Configuration
By default, the ADSL Modem/Router acts as DHCP
server and automatically assigns all required Internet settings to
your PCs, i.e., the DHCP clients. The predefined IP address and
DHCP pool is as below:
LAN Port IP address 192.168.1.1
USB Port IP address 192.168.1.2
Subnet mask 255.255.255.0
DHCP pool 192.168.1.3~34
These instructions assume that your PC meets the following
prerequisites:
1. Already connected to the device’s LAN port through its
network interface card (NIC) or connected via the USB
port.
2. Has the appropriate Ethernet adapter software (or the USB
driver if it is connected via USB port).
3. The TCP/IP protocol is installed. If not, refer to Microsoft
documentations to install the TCP/IP.
You need only to configure the PCs to accept the information
when it is assigned. Follow the instructions that correspond to the
operating system installed on each PC.
$
Windows 95, 98, Me PCs:
1. In the Windows task bar, click the Start button, point to
Settings , and then click Control Panel .
2. Double-click the Network icon.
3. On Configuration tab, select the TCP/IP network
associated with your network card and then click
Properties .
Note: If you are using USB PC, select the TCP/IP for your
USB device, e.g., Dynalink USB IAD LAN Modem .
4. In the TCP/IP Properties dialog box, click the IP Address
tab.
5. Click the radio button labeled Obtain an IP address
automatically .
6. Click OK twice to confirm and save your changes.
7. You will be prompted to restart Windows. Click Yes .