Wiring Instructions:
Before you decide where to wall-mount the filter, check that all cables can reach
to their appropriate connections.
The ADSL splitter/filter may be either hard wired, or simply plugged in. If either
the line, modem or the phone connection is to be hard wired, then:
1. Remove the Wall mount plate located on the back of the box with a flat screwdriver.
2. Remove the two screws.
3. Prepare the necessary cables by first stripping the outer jacket back 25mm. Do
not remove any insulation from the conductors to be terminated in the IDC.
4. Insert the conductors to the relevant location on the IDC block using an IDC
tool. See wiring configuration below for details.
5. Connect cable from ADSL Modem outlet to the connector marked ADSL.
6. Connect cable from in-house telephone wiring to the connector marked
telephone.
7. Connect the incoming subscriber line to the connector marked LINE.
8. Secure cables with cable ties.
9. Put connector cover back in place and relocate onto the wall.
Wall Mounting Instructions
The ADSL splitter/filter can be mounted on a wall by simply using the wall mounting
plate enclosed, and using the double-sided tape or the two screws provided.
This filter may be mounted either horizontally or vertically.
Follow these steps for screw mount
1. Use the wall mounting plate as template to mark the two positions for holes
where you wish to mount the box on the wall.
2. Drill the marked holes with a 6.0mm (0.24in) diameter drill bit to a minimum
depth of 35mm (1.38in).
3. Insert the wall plugs into the drilled holes (not supplied).
4. Position the wall mounting plate over the holes and insert the screws.
5. Position the filter over the wall mounting plate and push firmly into position
until it is secured.
