Dynacord VL 62, Brochure

Page: 64 / 120

CXM 15 / CXM 15W
64
CXM 15 / CXM 15W
COAXIAL MONITOR SPEAKER CABINET
•
Coaxial Monitor 15“ / 1.4“ 2-Way
•
102 dB SPL / 1 W / 1m
•
Max. 135 dB SPL / 1 m
•
Light Weight 19 kg
•
Switchable to Biamp Mode
•
FIR and IIR Presets available
The DYNACORD CXM 15 is a
lightweight wedge for professional
monitoring applications. The
DYNACORD DCX15450 two-way
15“ / 1.4“ transducer uses a
coaxially mounted HF unit and
can be used in passive or bi-amped
operating mode.
The acoustic crossover frequency
between the 15“ low-frequency
transducer and the 1.4“ mid-high
compression driver is at 1.2 kHz. The
slope of the built-in passive cross-
over network is 12 dB / octave.
Extremely precise vocal definition
is assured by the comparatively
low crossover frequency and the
coaxial transducer design. Power
amplifiers are connected to the
CXM 15 via Speakon NL4MPR
connectors. The pin assignment in
passive mode is 1+ / 1-. Switching
from passive mode to bi-amped
mode is performed by operation of
a slider switch. In bi-amping mode,
pins 1+ / 1- are connected to the
15“ low frequency section of the
CXM 15 and pins 2+ / 2- to the 1.4“
mid-high-frequency section.
The CXM 15 is equipped with three
Speakon sockets switched in parallel.
This simplifi es the daisy-chaining of
multiple wedges and pole-mounted
CXM 15 cabinets. The 1.4“ MF/HF
compression driver is safeguarded
against thermal overload by the
fully-electronic Voice Coil Tracking
Protection system, which exhibits
„soft“ switching characteristics,
sparing audiences the annoying
clicks and pops that are the bugbear
of conventional solutions. Both
FIR and IIR presets are available
for a wide variety of operating
modes. The CXM 15 is constructed
from birch plywood and therefore
extremely resistant to abuse on
the road. All cabinet connections
are slotted and glued. The surface
is protected by a hard-wearing
textured finish.
A powder-coated steel grille backed
by acoustic foam protects the
loudspeaker components from ac-
cidental damage. A recessed adapter
is provided to facilitate pole-moun-
ting. Handles have been integrated
into both sides of the CXM 15.
A version of the CXM 15 in white is
also available: the CXM 15W.
OPTIMIZED FACTORY PRESETS INCLUDING FIR-TUNE LINEARIZATION ARE
AVAILABLE FOR DSP 600, P 64 AND PowerH AMPLIFIERS WITH RCM-26
UNDER IRIS-NET.
dc loudspeaker_en_reprint062010.indd 64 dc loudspeaker_en_reprint062010.indd 64 05.07.10 14:06 05.07.10 14:06