Power Tool/Random Orbital Head Assemblies
1
96168
Screw
2
94594
Washer (2)
3
50855
Backing Pad - 8"
4
94595
Spacer
5
61369
Orbital Head Assy. - 5/8"-11
61370
Orbital Head Assy. - M14 x 2
6
90082
Natural Sheep Skin Buff
7
50679
Open-end Wrench (26mm)
8
95049
Hex Wrench (3/16")
Index Key
No. Part # Description
Storage/Handling:
• Do not rest tool on pad edge - may cause distortion of pad.
• Use of tool rest and/or balancers are recommended.
Installation/Pad Change/Storage
Random Orbital Head Installation Procedure:
1.
Make spindle stationary; use spindle lock if applicable and/or an
open-end wrench to hold spindle.
2.
Install orbital head assembly onto spindle and tighten.
3.
Tool will now accept desired pad accessory.
4.
Connect machine to power supply and check for proper operation.
Random Orbital Head Assembly Installation Complete.
Pad Change Procedure:
1.
Disconnect tool from power supply.
2.
Make sure pad is facing up, use
50679
Open-end Wrench to hold hex
of balancer shaft (hex portion of part located between,
61369/61370
Orbital Head Assembly and backing pad) use
95049
(3/16") Hex
Wrench to remove
96168
Screw and backing pad.
3.
Change pad and fasten with one
96168
Screw until tight.
Note:
When installing pad remember to use the correct spacer and
washers to ensure a proper fit, see diagram above.
4.
Tool will now accept desired pad accessory.
Pad Change Complete.
T
Torque:
N•m x 8.85 = In. - lbs.
KEY
Power Tool
(5/8"-11 Spindle) or (M14 x 2 Spindle)
Model: 51610 Shown
Dynabrade Models
Ready To Accept Accessory:
Electric: 51610
Premium Air: 51392, 51396 (M14)
Autobrade Air: 18050, 18053 (M14)
11.3 N•m
T
2
5
3
4
2
1
6
7
8
All Random Orbital
Assemblies Include
90082
Natural Sheep
Skin Buff.
MAXIMUM TOOL RPM MUST
NOT EXCEED RATING OF 3,200 RPM.
