NOTE:
Be sure to place all cables into the ditch to avoid the damage during assembling the
bottom cover.
NOTE:
Be sure to align Type-C connector to Top Cover, when place system board on the
unit..
2. Securing System Board with two M2.0x3.0x4.5and three M2.0x2.5x5.0 black
Phillips head screw.
( ▲ mark portions)
3. Connect following cable to the connector on System Board:
- Speaker cable from SPK.
-
LCD
cable from
CN6
.
-
IO
Board cable from
CON19
-
FFC-MB
terminal connected to
TP-CON1
- keyboard connection
KBCON1
,over the speaker wire wiring. -
FAN
cable from
CN21
.
- Battery Pack cable from
CN3.
-
RTC
Battery from
RTCCN1
.
- Released wireless antenna cables from top cover latch. -
Place System Board in correct position
- DC block paste high temperature adhesive paper
4.9 IO Board
Removing IO Board
Remove IO Board according to the following procedures and Figures 4-23.
1. Disconnect the following cable from the connector on IO Board: -
IO Board cable from JDB1
2. Remove three M2.0x3.0x4.5 black Phillips head screw securing IO Board.
3. Remove the IO panel Myla.
