33
TROUblESHOOTING
PROblEM
POSSIblE CAUSE
CORRECTIvE ACTION
No gas flow or an
obstructed gas flow.
• Tank valve not on or fully
opened.
• Empty tank.
• Poor connection between
valve regulator and LP cylinder
coupling.
• Burner inlet blocked.
• Fully open tank valve by turning
counterclockwise.
• Check fuel level and replace fuel if
necessary.
• Turn off grill knobs, close the LP
cylinder value at top of cylinder
and check the connection between
the regulator valve and cylinder
coupling. Disconnect and reconnect, if
necessary.
• Clean the burner inlet (venturi) and
burner as described by the Care and
Maintenance section in the manual.
The burner will not
light using the ignitor
procedure (weak or no
spark being generated).
• The ignition electrode may be
covered with grease or residue.
• The ignition electrode may
have a loose or disconnected
wire.
• Cracked or broken ignition
electrode.
• Dead battery or faulty battery
connection.
• Turn control knobs to the off position
and clean the ignition electrode with
rubbing alcohol and cotton swab.
• Check the connection and reconnect
any loose or disconnected wires.
• Replace ignition electrode (see
Replacement Parts List).
• Perform any of the following:
a. Replace battery.
b. Check to see if battery is
inserted correctly.
c. Check for any corrosion around
battery terminals.
d. Check wire connections as stated
above.
The burner will not
light with a match.
• Match not reaching burners
(when holding match with
hand).
• Empty tank.
• Poor connection between
valve regulator and LP cylinder
coupling.
• Burner inlet blocked.
• Use match holder found in cabinet
door.
• Check fuel level and refill tank if
necessary.
• Turn off grill knobs, close the LP
cylinder value at top of cylinder
and check the connection between
the regulator valve and cylinder
coupling. Disconnect and reconnect, if
necessary.
• Clean the burner inlet (venturi) and
burner as described by the Care and
Maintenance section in the manual.
