38
In the main menu, from Setting to Detect, you can see motion detect interface. See
X302H302H302H
Figure
4-16
X
. There are three detection types: motion detection, video loss, camera masking.
4.5.2
Motion Detect
Detection menu is shown as below. See
X303H303H303H
Figure 4-16
X
.
z
Event type: from the dropdown list you can select motion detection type.
z
Channel: select the channel to activate recording function once alarm occurred. Please make
sure you have set MD record in encode interface(Main Menu->Setting->Schedule) and
schedule record in manual record interface(Main Menu->Advanced->Manual Record)
z
Latch: when motion detection complete, system auto delays detecting for a specified time.
The value ranges from 10-300(Unit: second)
z
Region: Click select button, the interface is shown as in
X304H304H304H
Figure 4-17
X
.Here you can set motion
detection zone. There are 396(PAL)/330(NTSC) small zones.
z
Sensitivity: System supports 6 levels. The sixth level has the highest sensitivity.
z
Show message: System can pop up a message to alarm you in the local host screen if you
enabled this function.
z
Send email: System can send out email to alert you when alarm occurs.
z
PTZ activation: Here you can set PTZ movement when alarm occurs. Such as go to preset,
tour &pattern when there is an alarm. Click
“
select
”
button, you can see an interface is
shown as in
X305H305H305H
Figure 4-18
X
.
z
Period: Click set button, you can see an interface is shown as in
X306H306H306H
Figure 4-19
X
. Here you can
set for business day and non-business day. In
X307H307H307H
Figure 4-19
X
, click set button, you can see an
interface is shown as in
X308H308H308H
Figure 4-20
X
. Here you can set your own setup for business day and
non-business day.
z
Anti-dither:
Here
you
can set anti-dither time.
z
Alarm output: when alarm occurred, system enables peripheral alarm devices.
z
Tour: Here you can enable tour function when alarm occurs. It is a one-window tour. Please
go to chapter 5.3.9 Display for tour interval setup.
Please highlight icon
to select the corresponding function. After all the setups please click
save button, system goes back to the previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the video in
each channel may not be the same.
In
X309H309H309H
Figure 4-17
X
, you can left click mouse and then drag it to set a region for motion detection.
Click Fn to switch between arm/withdraw motion detection. After setting, click enter button to exit.
