Dyaco XE515SD-YE005, Service Manual

Page: 55 / 92

S S e e r r v v i i c c e e M M a a n n u u a a l l
8.7 Troubleshooting procedure matrix
Condition Reason Solve
LCDs not bright, incomplete or imperfect. 1. LCD light is broken.
2. Power to console too low. 1. Replace with new LCD or console.
2. Check AC power is 110-120V for 110V model(or
220V-230V for 220V model)
3. Check power to console.
4.Replace lower controller.
LCD displays not bright, incomplete or imperfect. 1. LCD displays are broken. 1. Replace with new console.
The incline position doesn’t match console 1 Console is not calibrated. 1 Calibrate the console.
INCLINE ERR ,INCLINE window displays
“INCLINE E3”. 1 Position sensor value of incline motor is
wrong.
1 Turn off the AC switch and turn on power again.
2. Calibrate the monitor.
Erratic pulse display. 1. Another chest belt in use around
Elliptical.
2. Other magnetic field disturbance.
3. Receiver is broken.
1. Check for other chest belt use around elliptical.
2. Change the position or direction of elliptical.
3. Replace with new receiver.
UP/DOWN button of
INCLINE ADJUSTMENT SWITCH can’t be used.
Incline button just can press UP, can’t press
DOWN.
Incline button just can press DOWN, can’t press
UP.
1 The connector of INCLINE CABLE
and CONSOLE not connected properly.
2. The connector of INCLINE CABLE
and INCLINE ADJUSTMENT SWITCH
W/CABLE not connected properly.
3 The connector of INCLINE CABLE or
INCLINE ADJUSTMENT SWITCH
CABLE
got damage.
4. Button of INCLINE ADJUSTMENT
SWITCH is broken.
5. The connector of INCLINE CABLE or
INCLINE ADJUSTMENT SWITCH
CABLE
got damage.
6. The connector of INCLINE CABLE or
INCLINE ADJUSTMENT SWITCH
CABLE
damaged.
1 Connect the wires again.
2. Connect the wires again.
3. Replace the cable.
4. Replace buttons.
5. Replace the cable.
6. Replace the cable.
Hand pulse lost its function. 1. Hands not on the hand pulse sensors 1. Two hands hold the hand pulse.