- 5 -
M965700 Rev. 1.1 (4/17)
10
• With HANDLE
(1)
in OFF position, turn on WATER SUPPLIES
(2)
and check all connections for leaks.
• Remove AERATOR
(3)
. First loosen aerator set screw with HEX WRENCH
(4)
supplied. Pull out AERATOR
(3)
with
AERATOR KEY
(5)
.
• Operate HANDLE
(1)
to flush water lines thoroughly.
• Replace AERATOR
(3)
and tighten set screw.
CHECK DRAIN CONNECTIONS
• Operate POP-UP KNOB
(6)
and fill lavatory with water. Check that DRAIN STOPPER
(7)
makes a good seal and retains
water in Sink. If DRAIN STOPPER
(7)
does not seal properly, please refer to Troubleshooting section in these instructions.
• Release POP-UP KNOB
(6)
down and check all drain connections and “P” trap for leaks. Tighten if necessary.
TEST INSTALLED FITTING
6
3
4
1
5
OFF
ON
HOT
COLD
“P” TRAP
WASTE
OUTLET
2
2
7
