- 4 -
M965700 Rev. 1.1 (4/17)
7
8
9
ATTACH CABLE CONNECTOR
CHECK OPERATION OF POP-UP
MAKE WATER SUPPLY AND WASTE CONNECTIONS
• Thread CABLE CONNECTOR
(1)
clockwise
onto DRAIN BODY CONNECTION
(2)
and
hand tighten.
Fig. A.
Your new POP-UP DRAIN installation is
now complete.
Fig. B.
Note:
Tailpeice on pop-up drain is 1-1/4" O.D.
Fig. B.
• Operate LIFT KNOB
(1)
to verify that STOPPER
(2)
opens and closes.
Note:
If STOPPER
(2)
does not open and close properly then refer to the
“troubleshooting section” of these instructions.
• Connect FLEXIBLE SUPPLIES
(1, 2)
directly to wall supplies.
Connection on fitting supplies are 3/8" compression. Connect
left SUPPLY
(1)
to Hot (Marked with a Red Band) and right supply
to COLD
(2)
wall supply.
• Faucet supplies are 20" long from faucet base.
Note:
If additional supply length is required, installer must
purchase additional parts separately.
Important:
If SUPPLY HOSES
(1, 2
) are to long, loop as
illustrated to avoid kinking.
• Connect 1-1/4" O.D. tailpiece on POP-UP DRAIN to
waste outlet.
2
1
1-1/4” O.D.
Fig.
A.
Fig.
B.
1
2
1
APPROX. 20
"
2
COLD
HOT
3/8" COMPRESSION
RED
BAND
BLUE
BAND
