- 5 -
HOT
2
2
COLD
“P” TRAP
WASTE
OUTLET
4
6
1
5
3
1
M965710 Rev. 1.0 (5/17)
12
13
14
• With HANDLE
(1)
in OFF position, turn on WATER
SUPPLIES
(2)
and check all connections for leaks.
• Remove AERATOR
(3)
. Loosen AERATOR HOUSING
(4)
and remove AERATOR
(3)
.
• Operate HANDLES
(1)
to flush water lines thoroughly.
• Replace AERATOR
(3)
and tighten AERATOR HOUSING
(4)
.
• Operate POP-UP KNOB
(5)
and fill lavatory with water.
Check that DRAIN STOPPER
(6)
makes a good seal and
retains water in Sink. If DRAIN STOPPER
(6)
does not
seal properly, please refer to Troubleshooting section in
these instructions.
• Push POP-UP KNOB
(5)
down and check all drain
connections and “P” trap for leaks. Tighten if necessary.
TO CLEAN AERATOR
• AERATOR
(3)
may accumulate dirt causing distorted
and reduced water flow. Remove AERATOR
(3)
and
rinse clean.
• Replace AERATOR
(3)
and operate handles several
times from OFF to ON position. Do not force,
handles turn only 90˚.
CONNECT DRAIN
TEST INSTALLED FITTING
CHECK DRAIN CONNECTIONS
WASTE
OUTLET
1-1/4" (32mm) O.D.
TAILPIECE
• Connect 1-1/4
"
(32mm) O.D. tailpiece on POP-UP DRAIN to waste outlet.
