- 2 -
M965481 Rev. 1.6 (5/17)
1
2
2a
HOSE ASSEMBLY
HAND SHOWER ASSEMBLY
• Insert FIBER WASHERS
(1)
into COUPLING NUTS
(2)
of SUPPLY HOSES
(3)
and tighten.
NOTE: Back flow prevention and 2.5 GPM flow restrictions are included with all
Roman tub sets with hand shower.
• T-PIECE
(8)
and COUPLING NUT
(9)
are factory pre-installed on SPOUT
SHANK
(1)
and must be removed to install spout. Unthread COUPLING NUT
(9)
and pull off T-PIECE
(8)
.
• Insert SPOUT SHANK
(1)
through center hole of sink or mounting surface.
Install WASHER
(2)
.
• Assemble RUBBER WASHER
(3)
, FIBER WASHER
(4)
and LOCKNUT
(5)
onto threads of SPOUT SHANK
(1)
. Tighten firmly.
• Grease O-RING
(6 & 7)
. Assemble T-PIECE
(8)
onto the SPOUT SHANK
(1)
and tighten with COUPLING NUT
(9)
.
• Slide the T-PIECE
(8)
onto SPOUT SHANK
(1)
until it makes contact
with the O-RING
(6)
. Thread COUPLING NUT
(9)
onto SPOUT
SHANK
(1)
. Rotate T-PIECE
(8)
about 10 degrees from center and
tighten securely. Make sure both O-Rings
(6 & 7)
are seated into
grooves of T-PIECE
(9)
.
SPOUT AND T-PIECE ASSEMBLY
CAUTION
Turn off hot and cold water
supplies before beginning.
IMPORTANT NOTICE TO THE INSTALLER
Please check with your local Code Authority for acceptable installation requirements forthis
Roman Tub set with hand shower. Some local codes may require a vacuum breaker and/or
a pressure balanced mixing valve to be installed in conjunction with this product.
• Drop SPRAY HOLDER
(4)
into the fourth hole of the
tub ledge or deck (12
"
max from SPOUT center)
directed towards tub center. Be sure O-RING
(5)
is properly seated in ESCUTCHEON
(6)
. Install
RUBBER WASHER
(7)
, FIBER WASHER
(8)
and
LOCKNUT
(9)
from underside of mounting
ledge. Secure SPRAY HOLDER
(4)
by tightening LOCKNUT
(9)
.
• Add SEAL WASHER
(10)
and connect
COUPLING NUT
(11)
of BRAIDED HOSE
(12)
to outlet nipple. Tighten firmly. Tighten SPRAY
REST
(19)
.
• Slip SHOWER HOSE
(13)
with
COUPLING NUT
(14)
through SPRAY
HOLDER
(4)
and ESCUTCHEON
(6)
.
• Install SEAL
(15)
into COUPLING NUT
(14)
.
Connect COUPLING NUT
(15)
to
HOSE NIPPLE
(16)
and tighten.
• INSTALL second SEA
L (15)
and
connect HANDS HOWER
(17)
to SPRAY HOSE END
(18)
. Hand tighten.
GROOVE
IN TEE
GROOVE IN TEE
10°
3
4
5
8
9
7
1
2
6
TRANSFER
KNOB
14
2
2
1
1
11
12
13
3
3
10
15
8
BRAIDED
HOSE
16
15
5
6
4
OUTLET
NIPPLE
9
18
7
3
19
17
