- 2 -
INSTALL CLOSET BOLTS
Install closet bolts in flange channel
and slide into place parallel to wall.
TIP:
Place 2 pieces of masking tape
on floor (as shown) to help with
alignment in step 4.
Apply weight evenly. Do not move
after placement. Water tight seal
may break.
7302408-100 (2/2020)
1
4
6
2
5
3
!
WARNING:
Overtightening of water supply
line nuts could result in breakage
and potential flooding. If the
connection leaks after hand
tightening, replace the supply
line. Do not use any type of
sealant on the water supply
connection.
Use of plumber’s putty,
pipe dope, or any other
type of sealant will void
the warranty.
For seat installation,
see instructions
included with seat.
*
!
CLOSET FLANGE
DRAIN
CENTER LINE
CLOSET BOLTS
VALVE
BODY
ADJUSTABLE
HEIGHT
WATER LEVEL
ADJUSTMENT
ROD
TANK
LEVER
FLUSH
VALVE
TOP
ARM
NIPPLE
Diagram 1
PARTS FOR WATER
CONNECTION
(SEE STEP 9)
CONE WASHER
FLAPPER
THREADED
SHANK
SHANK
WASHER
COUPLING NUT
(HAND TIGHT ONLY)
FILL
VALVE
FLOAT
CUP
CRITICAL LEVEL
MARK ("C.L.")
MUST BE
1" ABOVE
OVERFLOW PIPE
REFILL
TUBE
LOCK NUT
CLOSET BOLT
WASHER
NUT
Press
firmly.
WAX RING
7
ADJUSTMENTS
• Adjust water level. Water
level should be adjusted to
level indicated on tank
by adjusting float cup.
See Step 7 for water level
adjustment method
• If bowl fails to siphon, an
adjustment may be required
with the lift chain. Simply
remove the bead chain
from the retainment clip
and take up slack on the
chain, and reinsert on lift
rod. Make sure the chain
is not too taught.
Turn on water supply.
Submerge the FLOAT CUP
under the water for 30
seconds. Adjust the water
to desired level by turning
WATER LEVEL ADJUSTMENT
ROD and moving FLOAT CUP
up or down.