- 2 -
4
Place marble top upside down onto the cardboard spacer to cushion and prevent scratching. Do not place marble top on its
edges/corners or chipping can occur.
3
Remove lavatory from shipping container and carefully place in
center of marble top opening as an under counter mount
installation. Ensure lavatory is centered evenly over marble top
opening front to back, side to side and trace a pencil line
around the perimeter of the lavatory onto the underside of the
marble top
(4)
.
NOTE: Ensure “Overflow” of lavatory is installed towards
“Front” of console.
770283-100 (2/2020)
Typical installation includes wall preparation, installation of faucet and pop-up drain, supplies to house water system.
Console Mounting Provisions
- Whether the lavatory is used for replacement or new installation, the wall area behind the
console must be reinforced to provide secure mounting for the new unit.
Preparing Wall for Console Mounting
1.
Remove wallboard/covering from designated area.
2.
Toenail 2" x 6" (51 x 152 mm) cross piece between studs (or notch studs to accept a 1" x 6" (25 x 152 mm) crosspiece,
and attach securely). Place the console into desired position and check height for dimensional location of horizontal
crosspiece.
3.
Replace wallboard/finished wall media.
WALL PREPARATION:
1
NOTCH STUDS
OR TOE-NAIL
DRAIN PIPE
WATER
SUPPLY
PIPES
CONSOLE
CROSS-PIECE
SUPPORT
INSTALLING
CROSS-PIECE
Refer to exploded view. Set aside items
(1)
&
(2)
(left & right console frames)
and 2 horizontal support tubes
(3)
. Assemble support tube by sliding end of tube
over square connector. Set screw should be positioned on the bottom. Tighten
set screw using supplied hex wrench.
NOTE: There is a FRONT and REAR to the console frames that can be
identified by a slight opening on the top of the console frames
tubing, this is the rear.
2
CONSOLE
REAR
OPENING
