- 7 -
Control Cable Information
Included with the DX Engineering rotator is a control cable plug (DXE-LP20-F) that mates to the rotator cable
pigtail (DXE-LP20-M). This plug may be used to assemble your own rotator control cable. DX Engineering
also offers pre-made control cables with the connector installed in various lengths (see information above).
The cable needed for controlling the DX Engineering Rotator uses four wires. Two 12AWG wires for DC supply
to the motor and two 18AWG wires for the Pulse Sensor. For cable runs over 300 feet, use larger diameter
wire as needed to supply the rotator with 24 VDC at 3.1 amps nominal operating requirements.
DXE-LP20-F
Unpacking the DXE-RT4500HD Rotator from the custom made shipping box
Please review the important unpacking instructions that are included in the box to avoid damage or injury when
handling the DXE-RT4500HD Rotator.
