- 15 -
1. On the side of the rotator body, you will notice an aluminum hatch or door.
2. Using a straight slot screwdriver, rotate the 1/4 turn screw counter-clockwise to open the door.
3. You can then carefully pull out the magnetic pulse sensor assembly until you see the green connector.
4. Unplug and remove the old pulse sensor assembly.
1 2 3 4
5. Position the new replacement Pulse Assembly as shown.
6. Plug in the new replacement pulse sensor assembly.
7. When tucking the connector and wires into the rotator, push them toward the right side (as you are looking
at the opening in the rotator). This ensures the wires are kept away from any moving parts inside the rotator,
8. Carefully push the assembly in place and use a straight slot screwdriver and turn the 1/4 turn door screw
clockwise to lock it and the gasket in place.
5 6 7 8
