3
Introduction
There are two packaged systems available:
DXE-RFS-2P - Receive Four Square Array Controller & Control Box
The
DXE-RFS-2P
is a sophisticated receiving system that uses time delay phasing rather than the
conventional narrow-band, frequency dependent phasing systems. The time delay phasing is
directivity-optimized to produce wider and deeper rear nulls and a narrower main lobe. The result is
that noise and undesirable signals are greatly reduced for a superior front-to-rear ratio (F/R). Better
control of phase and currents provides a cleaner pattern than found on available transmit four square
arrays.
The
DXE-RFS-2P
is optimized to use DX Engineering’s Active
Vertical Antenna Package,
DXE-ARAV3-4P
. The two products
together offer great F/R response over octaves of bandwidth. DX
Engineering’s Active Receive Antenna System offers excellent
receiving performance from 100 kHz to 30 MHz while using only a
102 in. whip as the antenna element. A unique design makes it vastly
superior to traditional active antennas in both strong signal handling
and feedline decoupling. This results in significantly better weak
signal reception due to lower spurious signal interference and
reduced noise.
Finally, this system offers greater reliability in receiving applications. The
RFS-2
uses sealed relays
sized for receiving applications with silver contacts to prevent oxidation and contamination. Most
transmitting four square switches use large open-frame relays where the contacts are exposed to air
which can lead to contamination. Relays with brass contacts can oxidize leading to poor
conductivity.
Advantages of the
DXE-RFS-2P
Receive Four Square Antenna System over other small or
medium-size receiving arrays include:
•
Reduced susceptibility to high angle signals compared to EWE, Flag, Pennant, and K9AY
antennas
•
Excellent directivity in a small space for better signal-to-noise ratio
•
Switchable in four 90 degree spaced directions
•
Directivity over a very wide frequency range using DX Engineering active receive
elements
DXE-ARAV3-4P
•
Less physical space required than a Beverage antenna and active elements need only a
minimal ground system
•
Enhanced relay contact reliability
The
DXE-RFS-2P
includes the
DXE-CC-8A
Receive Four Square Switch controller. The
CC-8A
interfaces to the
RFS-2
through a 3 or 4 wire cable to select one of four directions on the
RFS-2
and to power the active elements. Economically priced
DXE-CW9
is
a 9 conductor Shielded Control
Wire which may be used.