- 15 -
When installing the unit, the four ground
spikes
must
be pushed into the soil to
provide a good ground.
If your soil is not a good ground (sandy,
real hard dirt, etc.), adding a customer
supplied ground rod which is connected
to the unit at one of the radial
connection points will help provide a
good ground.
Please
read and understand the instruction manual that comes with the
MFJ-927
Remote
IntelliTuner™ Automatic Antenna Tuner. There is information included in that manual that
is critical to proper operation of both the MFJ-927 Remote IntelliTuner™ Automatic
Antenna Tuner and the Bias "T". There is also troubleshooting information and tuner reset
information that may be very helpful.
Removing the Tuner
To access the inside of the MFJ-927 tuner it will have to removed from the shelf. Remove your
coaxial cable from the right angle UHF adapter and remove the wire going from the tuner's red
binding post to the MatchBoxx™. Remove the four hex head bolts holding the tuner on the shelf as
shown in
Figure 20
.
Figure 20
Installing the Optional 80 meter Tuning Coil - DXE-SA80-AOK
The
DXE-SA80-AOK
80 meter coil add-on kit is custom designed for use with the ATSA antenna
system. In some ATSA antenna installations with excellent radial systems, achieving the best SWR
on a vertical element for 80 meters may be difficult without some means of adjusting
feedpoint impedance.
