June, 2000
Page 3
949-0532-1
RANGE SELECTION SWITCH BANK (SW-4)
Turn ON the switch for the scale desired. All other switches should
be OFF. If BIPOLAR OUTPUT is selected, the scale will be from
MINUS-SELECTION to PLUS-SELECTION (eg. -10 TO +10 VDC)
1
2
3
4
5
6
7
8
ON
1
2
3
4
5
6
ON
290-2893
SW4
SW3
OUTPUT
VOLTAGE
CURRENT
UNIPOLAR
BIPOLAR
ZERO BASED
ZERO +20%
1V
5V
10V
1mA
5mA
20mA
NOTE: SWITCH 8
IS NOT USED
MODE
RANGE
1 2 3 4 5 6 7 8
1 2 3 4 5 6
KEY
= ON
= OFF
BLANK =
NOT
APPLICABLE
WARNING: Do not attempt to operate this de-
vice with the cover removed. Potentially le-
thal voltage is present on some of the internal
components. Do not open the unit. There are
no internal adjustments or user serviceable
parts in the unit.
Mounting
Mount the unit in a panel on an industry standard 35 mm DIN rail. An
optional surface mounting kit is available from the factor y (P/N
35DINADPTR).
To install, hold the SC468 so that the front is higher than the rear. Place
the upper slot on the rear of the SC468 on the top edge of the DIN rail.
Slowly rotate the front down until the bottom spring clip snaps over the
bottom edge of the DIN rail.
To remove from the DIN rail, place a small slotted screwdriver in
the slot in the spring clip under the housing. Pry the slot down-
ward to release the SC468 from the bottom of the rail.
