DWT BM-110 T, Original Instructions Manual

Page: 14 / 76

14
English
Recommendations
on the power tool operation
Drilling (see fig. 9-12)
• Grease the drill bit regularly when drilling holes in met-
als (except drilling non-ferrous metals and their alloys).
• When drilling hard metals, apply more force to the
power tool and lower the rotation speed.
• When drilling large diameter holes in metal, first
drill a hole with a smaller diameter and ream it till the
necessary diameter (see. fig. 9).
• In order to avoid splitting of the surface at an exit
point of a drill bit when drilling holes in wood, follow the
instructions shown in figure 10.
• In order to decrease dust production when drilling
holes in walls and ceilings, take actions indicated in
figure 11.
• When drilling holes in glazed ceramic tiles, in order
to improve the drill centering accuracy and to save the
glaze from damage, apply adhesive tape to the pre -
sumed hole center and drill after that (see fig. 12). Start
drilling at lower speed increasing it as the hole deepens.
Screwing the screws (see fig. 13)
• To make fastening of screws easier and in order to
prevent cracking of the work pieces, first drill a hole
with a diameter equal to 2/3 of a diameter of the screw.
• If you are connecting work pieces with the help of
screws, in order to achieve durable joint without get -
ting cracks, fracturing or layering, take actions shown
in figure 13.
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains .
Cleaning of the power tool
An indispensable condition for a safe long-term
exploitation of the power tool is to keep it clean.
Regularly flush the power tool with compressed air
thought the ventilation slots 4 .
After-sales Service and Application Service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts. Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com .
•
Transportation
of the power tools
Categorically not to drop any mechanical impact on
the packaging during transport.
• When unloading / loading is not allowed to use
any kind of technology that works on the principle of
clamping packaging.
Environmental
protection
Recycle raw materials instead of
disposing as waste.
Power tool, accessories and packaging should be
sorted for environment-friendly recycling.
The plastic components are labelled for categorized
recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
The manufacturer reserves the possibility to introduce changes.