www.dwt-zelte.com
Bora Air
Unscrew all valves from the air tubes
and screw back. Make sure that
winding is not uptight. In this case
the air tubes will loose pressure.
Make sure that release valve
is mounted to pump as shown
on the picture. Do dot use any
other electrical aggregates with-
out release valve but the one
witch was delivered. The tubes
take maximum 0,5 bar / 7psi.
Tube pressure must not exeed
0,5 bar / 7psi!
Unscrew little cap on top of the
valves and start infl ating the middle
section(s). Carry on with the other
tubes at the sides. Screw back the
little cap.
061443_Aufbau_Bora Air.indd 10
061443_Aufbau_Bora Air.indd 10
04.11.13 08:04
04.11.13 08:04
