
21
Seat Back Monitor
Installation and Connections
WARNING:
Make the correct connections.
Failure to make the proper connections may
result in fire or product damage.
Use only in cars with A 12 volt negative ground.
(Check with your dealer if you are not sure.) Failure
to do so may result in electric shock or injury due to
electrical shorts.
Do not allow cables to become entangled in
surround objects.
Arrange wiring and cables in compliance with the
manual to prevent obstructions when driving.
Do not splice into electrical cables.
Never cut away cable insulation to supply power to
other equipment. Doing so will exceed the current
carrying capacity of the wire and result in fire or
electric shock.
Do not damage the electrical wire when drilling
holes.
When drilling holes in the console box for
installation, takes precautions so as not to contact,
damage the electrical wiring. Failure to take such
precautions may result in fire.
Keep small objects such as batteries out of the
reach of children.
Swallowing them may result in serious injury. If
swallowed, consult a physician immediately.
PRECAUTIONS:
Be sure to disconnect the cable from the (-)
battery post before installing this unit.
This will reduce any chance of damage to the unit in
case of a short-circuit.
Be sure to connect the color coded leads
according to the diagram.
Incorrect connections may cause the unit to
malfunction or damage to the vehicle's electrical
system.
When making connections to the vehicle's
electrical system, be aware of the factory
installed components. Do not tap into these leads
to provide power for this unit.
Failure to do so may result in damage to the unit or
vehicle. When it doubt, please consult your dealer.
This unit uses female RCA-type jacks for
connection to other units (e.g. amplifier) having
RCA connectors.
You may need an adaptor to connect other units. If
so, please contact your authorized dealer for
assistance.
Before installing or connecting the unit, please read
the following and page 2~4 of this manual
thoroughly for proper use.
CAUTION:
The back seat passenger
while operating the unit.
Have the wiring and installation done by experts.
The wiring and installation of this unit requires
special technical skill and experience. To ensure
safety, always contact the dealer where you
purchased this unit to have the work done.
Use specified accessory parts and installs them
securely.
Be sure to use only the specified accessory parts.
Use of other than designated parts may damage this
unit internally or may not securely install the unit in
place. This may cause parts to become loose
resulting in hazards or product failure.
Arrange the wiring so it is not crimped or
pinched by a sharp metal edge.
Route the cables and wiring away from moving parts
(like the seat rails), sharp or pointed edges. This will
prevent crimping and damage to the wiring. If
wiring passes through a hole in metal, use a rubber
grommet to prevent the wires insulation from being
cut by the metal edge of the hole.
Drilling can cause airborne debris.
Airborne debris can cause serious injury to the eyes.
Wear protective eye-wear when drilling.
must fasten the seatbelt
●
This Stanchion Mount is suitable for DVS Seat Back
Monitor only.
●
The fixity and shape of the seat will affect the
vibration of the screen.
●
Do not install this monitor in a place other than the
car.
●
The screws will loose due to the vehicle
vibration. Please check and confirm whether
the screws loose before each using.
●
Best viewing distance for DVS Seat Back Monitor is
80cm.
Summary of Contents for TH102MS
Page 34: ...Seat Back Monitor 33...
Page 35: ...34 Rear Seat Entertainment...
Page 36: ...DVS MS 980916 v0924...