15) Disconnect tools.
-- When not in use, before servicing and when changing accessories such as blades, bits and cutters.
16) Remove adjusting keys and wrenches.
-- Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before
turning it on.
17) Alvord unintentional starting.
-- Do not carry a plugged-in toot with a finger on the switch. Ensure switch, is off when plugging in.
18) Use outdoor extension leads.
- When tool is used outdoors, use only extension cords intended for outdoor use.
19) Stay alert.
-- Watch what you are doing, Use common sense. Do not operate tool when you are tired.
20) Check damaged parts.
-- Better further use of the tool, a guard or other part that is damaged should be carefully checked to
determine that it would operate properly and perform its intended function. Check for alignment of moving
parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect
its operational. A guard or other part char is damaged could be properly repaired or replaced by an
authorized service center unless otherwise indicated in this instruction manual. Have defective switches
replaced by an authorized service facility. Do not use the tool if the switch does not turn it on and off.
21) Warning.
--The use of any accessory or attachment, other than those recommended, in this instruction manual,
may present a risk of personal injury.
22) Have your tool repaired by a qualified person.
-- This electric tool is in accordance with the relevant safety requirements. Repairs should only be
carried out by qualified persons using original spare parts, otherwise this may result in considerable
danger to the user.
Safety Instructions for Spray Guns
l
You may only spray coating materials such as paints, varnishes, glazes, etc. with a
flashpoint of 21°C (32°C in UK) and higher without additional warning. (German
classifcation of coating material is hazard classes A II and A III, see material tin.)
l
The device may not be used in workplaces covered by the explosion-protection regulations.
l
There must be no sources of ignition such as, for example, open fres, smoke of lit
cigarettes, cigars and tobacco pipes, sparks, glowing wires, hot surfaces, etc. in the vicinity
during spraying.
l
Do not spray any substances whose hazard potential is not known.
l
Before working on the spray gun remove the power plug from the socket.
l
Do not use the spray guns to spray flammable substances.
l
The spray guns are not to be cleaned with flammable solvents which have a flashpoint
under 21°C.
l
Caution against dangers that can arise from the sprayed substance and observe the text
and information on the containers or the specifications given by the substance
manufacturer.
16
